- ページ 3
屋外用家具 Anova D1007のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Anova D1007 3 ページ。 8' perforated metal picnic table, ada compliant, traditional edge, portable mount
Anova D1007 にも： 組み立て説明書 (2 ページ)
ページを印刷する
5. Locate the four Rubber Feet and place them in the outermost
holes on the bottom of the supports. Use the Rubber Mallet to set
the Feet into place.
6. Locate one of the Cross Braces and position it so that the
mounting hole in one end aligns with the mounting hole in the
bracket in the center of the Support. Put a Washer on one of the
Bolts and insert the Bolt through the Cross Brace and Support
Bracket and put a Washer and Flanged Nut on the end of the Bolt.
Leave the hardware finger tight so that adjustments can be made
while assembling and leveling.
Position the other end of the Cross Brace so the mounting hole
aligns with the hole closest to the center of the Tabletop Bracket.
Install a Bolt and Washer through the Cross Brace and the
Tabletop Bracket and install a Washer and Flanged Nut on the end
of the Bolt. Again, leave the hardware finger tight.
7. Attach the other Cross Brace to the Tabletop and other Support
Bracket in the same manner. Leave the hardware finger tight.
8. Locate one of the Seats and position it up to the Support Seat
Brackets. Line up the mounting holes in the Seat with the mounting
holes in the Support Seat Bracket. Insert a Bolt with Washer through
the each of the sets of mounting holes and tighten finger tight.
Repeat this step for the Seat on the other side of the Table.
9. Turn the table right side up and tighten all hardware while checking
with a Level.
10. Move the assembled Table to the desired location.
11. Retighten hardware two weeks after initial assembly.
•
Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,
missing, or broken hardware, and general instability.
•
Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced.
wArnInG
•
Repairs must be made using only factory authorized parts and methods.
cAre AnD
•
Do not drag the assembled unit across any surface.
mAIntenAnce
•
This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to
remove surface dirt. Do not clean with a solvent or petroleum based products.
211 No
St. Louis, MO 63141
ASI 134
rth Lindbergh Blvd.
Rubber
Foot
Bolt and
Washer
Cross Brace
Washer and
Flanged Nut
Bolt and
Washer
Washer and
Flanged Nut
tel: 888.535.5005
web: anovafurnishings.com
Rubber
Washer and
Foot
Flanged Nut
Bolt and
Washer
Support Seat
Bracket
10/2012