- ページ 8

電動工具 Anova TP3002のPDF ユーザーマニュアル/取扱説明書をオンラインで閲覧またはダウンロードできます。Anova TP3002 11 ページ。 Battery pruning shears

7. Replace blade8. Insert nut9. Install lock nut

Support knife and movable knife can be replaced independently; As a replacement, don't worry

about too small a blade opening; After recovering the electricity of the scissor, the normal opening size

will recover automatically.

4. Maintenance

1. Do not cut branches outside the cutting range; do not cut non-vegetable materials, such as metals and

stones, etc. do not use clamps or the like to hold the scissors; always replace the cutting blade, if it is

worn or damaged.

2. Keep the cutting equipment clean, clean the scissors, batteries and charger with a clean cloth (do not

use corrosive detergents!) and a soft brush or dry cloth to clean the dust on the upper scissors.

3. Do not immerse scissors, batteries, and charger in water or other liquids;

4. Use the equipment correctly; stop using it when there is damage to the scissor, batteries and/or

chargers.

5. If the switch can't turn the scissor on or off, please don't use the scissor. It will be dangerous to control

the scissor without the switch properly. Replace and repair the switch in this case always before using

the scissor again.

6. Make sure the switch keeps the shear off when replacing accessories or storing the pruning shears.

Such a preventative measure will reduce the risk of accidentally activating the scissor and causing injury

to the user.

7. Turn off the pruning shears if you are not going to use them and store them out of the reach of

children. It is dangerous to allow inexperienced persons and untrained users to operate the pruning

shears.

8. When using pruning shears, respect the tool and its specific use for which it was designed. Consider

the work environment and the tasks to be performed; You can cause hazards and damage by using

improperly functioning pruning shears.

9. After use, please remove the dirt on the movable knife and the supporting knife, add lubricating oil or

motor oil on the contact part, make the knife keep in good sharp state to extend its service life and to

next uses.

1. Use the battery as the only valid power source for your electric pruning shears. Do not use the

battery as a power source for any other power tools not listed.

2. Do not charge the battery in temperatures below 0ºC or above 45ºC; this can damage the battery

and charger.

3. Make sure the battery switch is turned off before connecting the power cord; if it were open it could

create a problem when connecting to the scissor.

4. Use only the charger assigned by the manufacturer to charge the battery; It may cause battery fire