ページを印刷するPROGRAMMING ADDITIONAL ACCESS CODES
Up to 15 access codes in addition to the Master Code can be entered from the
keypad.
∗
Enter [
][5][Master Code]. The "Program" light will flash and the zone lights will
show which of codes 1 to 8 have already been programmed. To enter a new
code or change an existing code, first press the code number (1 to 8) and then
enter your [4 digit] code. To erase a code, press [
code. Note that the [
For codes 9 to 16, after entering [
"Armed"and "Program" lights will flash and the zone lights 1 to 8 will indicate
which of codes 9 to 16 have been entered. As above, to change or enter a code,
select the code by pressing 1 to 8 and then enter your [4 digit] code. Entering
∗∗∗∗
[
] erases a code. Pressing [9] again will change back to codes 1 to 8.
Pressing [#] returns you to ready mode. Access Code 16 ([
Code][9][8][4 digits]) can be set up by your installer to be used by a maid or
other service personnel one time only. Each time you enter this code, it can be
used to disarm your system but is erased when used to arm the system, ensuring
just one-time access.
QUICK-ARM FEATURE
When the Quick-Arm feature is enabled, the panel may be armed simply by
∗
entering [
][0] instead of a 4 digit code. The [
panel.
∗
Enter [
][6][Master Code][4] to turn ON and OFF the Quick-Arm feature. When
the command is entered, the keypad will beep 3 times if the feature is being
enabled and will sound one long beep if the feature is being disabled.
Press [#] to return to Ready.
QUICK EXIT OPTION
This feature, if selected by your installer, allows one exit with the system armed
without affecting its current armed status.
∗
Pressing [
][0] gives you 2 minutes to exit if you have already armed the system.
This is useful if you want to exit while preserving the protection for someone left
on the premises. Once you have exited, the system will be armed as before. If
the zone is open after 2 minutes or there has been more than one exit, the pre-
alert will sound.
DOOR CHIME FEATURE
The door chime feature is used, while the panel is disarmed, to provide a tone
from the keypad each time a door or window is opened or closed. The doors and
windows which will provide this indication are programmed by your installer.
∗
Enter [
][6][Master Code][6] to turn the door chime feature ON and OFF. When
the command is entered, the keypad will beep 3 times if the feature is being
enabled and will sound one long beep if the feature is being disabled.
∗
] and [#] keys cannot be used in a code.
∗
][5][Master Code], press [9]. The "Ready",
∗∗∗∗
∗
][0] command will not disarm the
8
] instead of a [4 digit]
∗
][5][Master