- ページ 11

IPカメラ Ansel Pan/Tilt & Dome TypeのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Ansel Pan/Tilt & Dome Type 12 ページ。 Multi-profile network cameras: pan/tilt & dome type

ページを印刷する

If difficulty is met, please refer to the following steps to establish the connection:

The networked device must be installed and powered ON.

If the networked device's default IP Address (192.168.0.100) is already used by

another device, the other device must be turned OFF until the device is allocated a

new IP Address during configuration.

4. 3G Mobile Phone (3GPP) Usage

The device is 3GPP compatible by default. To view live video over 3GPP, here is a

briefly steps. Please check user's manual inside product CD for detail

Step 1: You must apply a 3G mobile phone with 3GPP service. Please contact your

3G telecom service provider for detail.

Step 2: Check that the IP camera has a completely PUBLIC IP address, i.e. no

ports blocked by a firewall. It is highly recommended that you have a fixed and

public IP address without any firewall blocked

Step 3: check RTSP port and the default port is 554.

Step 4: Bitrate

Setting

Video

than 128 kbit/s.

To use the 3GPP function, in addition to previous section, you might need more

information or configuration to make this function work.

Note that to use the 3GPP function, it strongly recommends to install the Networked

Device with a public and fixed IP address without any firewall protection.

Bit rate, set the maximum bit rate to lower

MP4/QQVGA