- ページ 3

煙警報器 DSC WS4916 SeriesのPDF 設置および操作説明書をオンラインで閲覧またはダウンロードできます。DSC WS4916 Series 4 ページ。 Wireless smoke deteçtér
DSC WS4916 Series にも：据付・取扱説明書 (8 ページ), 据付・取扱説明書 (9 ページ), 据付・取扱説明書 (8 ページ), ユーザーマニュアルと設置手順 (17 ページ), 据付・取扱説明書 (8 ページ)

ページを印刷する

Owners Instructions

Fire Safety In The Home

Most fires occur in the home, and to minimize this danger, it is

recommended that a household fire safety audit be conducted

and a family escape plan be developed.

Household Fire Safety Audit

1. Are all electrical appliances and outlets in safe condition?

Check for frayed cords, overloaded lighting circuits, etc. If

you are uncertain about the condition of your electrical

appliances or household service, have a professional evalua-

tion.

2. Are all flammable liquids safely stored in closed containers,

and in a cool and well ventilated area? Cleaning the unit

with flammable liquids should be avoided.

3. Are hazardous materials such as matches out of the reach

of children?

4. Are furnaces and wood burning appliances properly

installed, clean, and in good working order? If in doubt,

have a professional evaluation.

Family Escape Planning

There is often very little time between the detection of a fire

and the time it becomes deadly. Because of this, it is very impor-

tant that a family escape plan be developed and rehearsed.

• Every family member should participate in developing the

escape plan.

• Study the possible escape routes from each location within

the house. Since many fires occur at night, special attention

should be given to the escape routes from sleeping quarters.

• It is essential that escape from a bedroom be possible without

opening the interior door. Consider the following when mak-

ing your escape plans:

• Ensure that doors and windows that open to the outside are

easily opened. Ensure that they are not painted shut and that

the locking mechanisms operate smoothly.

• If opening or using the exit is too difficult for children, the eld-

erly or handicapped, plans for their rescue should be devel-

oped. This plan includes making sure that those who are to

perform the rescue can promptly hear the fire warning signal.

• If the exit is above the ground level, an approved fire ladder or

rope should be provided, as well as training in its use.

• Exits on the ground level should be kept clear. Be sure to

remove snow from exterior patio doors in the winter and that

outdoor furniture or equipment does not block exits.

• The family should have a predetermined assembly point

where everyone can be accounted for; for example, across

the street or at a neighbor's house.

• Once everyone is out of the house, call the Fire Department.

• A good plan emphasizes a quick escape. Do not investigate

first or attempt to fight the fire, and do not attempt to rescue

belongings or valuables as this takes up time. Once outside,

do not re-enter the house; wait for the Fire Department.

• Write the plan down and rehearse it frequently so that should

an emergency ever arise, everyone will know what to do.

Revise the plan as conditions change; for example, when

there are more or fewer family members in the home or if

there are changes to the house.

• Make sure your fire warning system is operational by con-

ducting weekly tests. If you are unsure about system opera-

tion, contact your smoke detector installer or dealer.

• DSC recommends that you contact your local Fire Department

and request further information on home fire safety and

escape planning. If available, have your local fire prevention

officer conduct an in-house fire safety inspection.

Testing Your Smoke Detector

Follow the test procedure described here or contact your

smoke detector dealer or installer for testing instructions.

DSC recommends that you test the entire alarm system

at least once a week to verify the operation of all system

functions.

Smoke Detector Unit Test

Initiate test by pressing the test button for 5 seconds (min.), the

sounder makes clicking noises during this time. Press the button

until the unit alarm sounds, an alarm should be sent to the con-

trol panel. When the button is released, the alarm should cease.

If this does not occur, ensure batteries are the correct type, in

good condition and are installed correctly (see 3. Install Batter-

ies in the Installation Instructions section).

Upon completing the functional testing of the smoke detector,

check the unit's sensing chamber to ensure proper operation. To

test the sensing chamber, wave a lit cotton wick or punk stick

around the outside of the unit until a generous amount of

smoke enters the sensing chamber or the unit alarms. If the

smoke detector does not function properly, call your smoke

detector installer or dealer for service.

Owners Maintenance

The smoke detector is designed to require minimum mainte-

nance. If the case becomes dusty, vacuum with a small brush

attachment. If the case is greasy, wipe the case gently with a

soft cloth slightly dampened with soapy water.

Never disassemble the smoke detector; there are no

user serviceable parts inside the unit. You may only

remove detector from backplate to replace batteries if

not serviced by installer.

CAUTION:

This

product

improper handling may result in a HEAT, EXPLOSION

or FIRE causing personal injury. DO NOT recharge bat-

teries. Follow the battery manufacturer's safety

instructions. Dispose of used batteries in accordance

with the regulations in your area.

Never paint the unit. Paint may prevent smoke from

entering the unit. If you are planning renovations or

repainting, contact your installer and ask that the unit

be temporarily removed until work is complete.

If the unit is located in an area where it is exposed to high levels

of dust or insects and causes false alarms, it may require service;

contact your smoke detector installer or dealer.

Testing and maintenance procedures shall be in accordance

with CAN/ULC-S552-02.

uses

lithium

batteries,