- ページ 10
防犯カメラ ATV NBW4212MのPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。ATV NBW4212M 13 ページ。 Bullet network camera
ページを印刷する
2.3 Resetting to the factory default settings
To reset the network camera to the original factory settings, go to the Setup > System >
Maintenance web page (described in "System > Maintenance" of User Manual) or use the Reset
button on the network camera inside the bottom cap.
•
Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings using the
Reset button.
1)
Switch off the network camera by disconnecting the power adapter.
2)
Open the top cap.
3)
Press and hold the Reset button with a straightened paperclip while reconnecting the
power.
4)
Keep the Reset button pressed about 5 or more seconds.
5)
Release the Reset button.
6)
The network camera resets to factory defaults and restarts after completing the factory reset.
7)
Close the bottom cap tightly to ensure waterproof.
CAUTION: When performing a Factory Reset, you will lose any settings that have been
saved. (Default IP 192.168.30.220)
10