- ページ 2

ネットワーク・ルーター 3onedata IES615-2D SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。3onedata IES615-2D Series 5 ページ。 Managed industrial ethernet switch
3onedata IES615-2D Series にも：クイック・インストール・マニュアル (3 ページ)

ページを印刷する

1. Power input terminal block

2. Ground screw

3. 2-pin terminal block for relay output

4. DIP switches for default factory

5. Screw holes for Wall Mounting Kit

6. DIN-Rail mounting kit

7. System running LED

8. Link/ACT LEDs

9. Power indicator (PWR1, PWE2)

10. Serial port transmits and receives data LED

11. RS-232 serial port (DB9M)

12. 10Base-T /100Base-TX Ethernet port

13. 100Base-FX fiber port

14. RS-485/422 serial port (5 bits terminal block)

Power supply input

The switch have redundant power input, provides one terminal

block (4 bits) for PWR1 and PWR2 input. The redundant power

can be used single and used two self-governed power to supply to

the system, PWR1 and PWR2 input at the same time, when

neither of

these two power fails, the other power acts as a

backup, and automatically supplies power needs, ensure running

Ethernet reassuring. Voltage input range is 12 48VDC (terminal

block defined as: V1- V1+ V2- V2+).

Dimension

The series of switches are the same size, and the number of the

Ethernet interface is different. Unit (mm)

DIP Switch

Top panel provided 4 bits DIP switch to do function configure

OFF is default factory ,1 and 2 keep for future function. 3 is

AT mode. 4 is recovery default factory. Please power off and

power on when you change the status of DIP switch.

Relay connection

The relay owns two contacts of the terminal block on the top

panel of the Switch series. It is used to detect both power failure

and port failure. The open circuit state in normal non alarm state,

when there is any alarm information to the closed state. The relay

- 2 -

can external alarm lights or alarm buzzer or external switch signal

acquisition device in order to timely notify operators when an

alarm occurs.

Console port

This series product provided 1pcs procedure test port based in

serial port. It adopts RJ45 interface, located in top panel, can

configure the CLI command through RJ45 to DB9 female cable.

Communication connector

10/100BaseT(X) Ethernet port

The pinout define of RJ45 port display as below, connect by UTP

or STP. The connect distance is no more than 100m. 100Mbps is

used 120 of UTP 5, 10Mbps is used 120 of UTP 3 ,4, 5.

RJ 45 port support automatic MDI/MDI-X operation. can

connect the PC, Server, Converter and HUB .Pin 1,2,3,6

Corresponding connection in MDI. 1→3, 2→6, 3→1, 6→2 are

used as cross wiring in the MDI-X port of Converter and HUB.

10Base-T/100Base-TX are used in MDI/MDI-X, the define of Pin

in the table as below.