- ページ 4

エクステンダー Anywhere WEBWHIP WIFI-1のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Anywhere WEBWHIP WIFI-1 16 ページ。 Long-range wi-fi receiver

INSTALLATION

1. WebWhip kit

2. Plug travel adapter (if using in any other country other than the US)

3. Pliers (For rail or post installation. Refer mounting options below)

4. Screws and Screw driver (For surface mounting. Refer mounting options below)

5. Laptop with an Ethernet port (not included)

6. Wireless router (if sharing Internet via Wi-Fi. Not included)

Parts included:

1. Wi-Fi Antenna

2. L-Bracket

3. Hex-nut

4. U-Bolts x2

5. Clamping Bracket x2

6. Flat Washer x4

7. Spring Washer x4

8. Nut x4

9. Wi-Fi Radio

10. Coupling Ring (attached to the radio)

11. End cap

12. Rubber Grommet

Shown on next page:

13. Power injector

14. Ethernet cable

15. AC power supply

16. DC power cord

1. Horizontal rail: Assemble the U-bolts and brackets

vertically as shown in image.

2. Vertical post: Square bolt-hole pattern on L-bracket

allows U-bolts to be assembled horizontally to allow

mounting on a vertical post.

3. Flat Vertical surface: Mounting on a ﬂat vertical surface

can be done through screwing the L-bracket directly

onto the mounting surface using screws (not included)

to match the ¼" (6.35mm) mounting holes.

Note: Always mount the device such that the antenna is

pointing vertically upward and is in clear line of sight with

the transmitting Wi-Fi hotspot. Mount away from other

transmitters to avoid possible interference.

WIFI-1 / WebWhip

™

Wi-Fi Receiver Kit

INTRODUCTION

Page 3