- ページ 13
ミシン Duerkopp Adler 274のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Duerkopp Adler 274 18 ページ。 Preface and general safety notes
Duerkopp Adler 274 にも： 取付説明書 (2 ページ)
ページを印刷する
3.3 Replacing the Bobbin and Setting the Looper Thread Tension
- Risk of Injury -
Turn the main switch off!
Removing the Bobbin
Lift up lid 3 and remove the upper part of the bobbin case
with the bobbin.
3
4
Inserting the Bobbin
The insertion of a new, filled bobbin can be seen in the
following illustration.
The thread is pulled in the slit a under the leaf spring b up
to the hole c. When the thread is pulled off the bobbin
must turn in the direction of the arrow.
Important Note!
In order that the bobbin brake spring 5 can move freely
the area behind it is to be cleaned at regular work
intervals of sewing dust. Raise the spring, e.g. with a
needle, and blow out.
6
5
6
7
Setting the Looper Thread Tension
With a recommended looper thread tension of e.g. 30g,
15g should be achieved through the brake spring 5 and
15g through the tension spring 7.
As the base position of the tension spring 7 the following
applies:
Allow the bobbin case to slowly lower through its own
weight. See sketch.
The brake spring 5 blocks the run-on of the bobbin during
thread trimming.
Set its braking effect sensitively.
15