- ページ 8
ラボラトリー機器 Airvent UV-C FiltAir 45のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Airvent UV-C FiltAir 45 16 ページ。
ページを印刷する
Airvent UV-C FiltAir Instruction Manual
Separately Packed Accessories
The UV-C lamps, screws, dowels and power cord can be found in
a seperate package inside the UV reactor. These must be removed
from the inside and placed in a safe place until the installation.
Mounting the legs on the unit (optional accessory)
Preparing Mounting Holes
A)
Based on the Cardboard Template (Suggested Method)
The packaging consists of two identical corrugated cardboard
parts, which can also be used as a mounting template. On
the inside, marked points indicate where the mounting holes
should be drilled on the wall.
Size
UV-C FiltAir 15
UV-C FiltAir 30
UV-C FiltAir 45
UV-C FiltAir 75
Place the template on the wall at the designated location of the
unit. Make sure that the template is meeting the floor, so the unit
will be installed at the right height. Mark the mounting points on
the wall with a sharp tool (e.g. a screwdriver or a fixing screw). After
removing the template, the boreholes can then be drilled in. In
the case of damaged packaging, the holes can also be made as
shown in the figure. The fastening dowels depend on the material
of the wall. The device is supplied with dowels suitable for fixing
to solid (eg concrete, brick) wall materials. In the case of other wall
constructions, a suitable fastening element must be used.
8
Remove the Filter
After turning the filter clamps, the filter can be tilted and re-
moved from the filter housing by reaching under the frame of
the filter.
The removal of the filter
C (mm)
400
600
600
1050
Packaging cardboards can be used as a mounting template
Ø10 4x
C+/–2