ページを印刷するConnecting the data link
Connecting the data link
To connect this light to data:
1. Connect the DMX data output from the controller to the closest this light
male 5/3-pin XLR DMX input connector.
2. Connect the DMX output of the fixture closest to the controller to the DMX
input of the next fixture and
continue connecting fixtures output to input.
3. Terminate the last fixture on the link with a 120 Ohm resistor.
When th
turned on , the display screen and key button get flash
is light
in every second once the fixture without the DMX signal.When insert
DMX signal,the display screen and key button stop flashing, it stand
for run into the DMX control mode. 20 seconds later,the display will
be in power save mode and the the key button indicator turn off.
Setup
Control panel and menu navigation
This light
control center to
set the DMX. When you choose a
menu press
After finding your menu, Press
After out of menu,press
OK
,
to enter
to see the working condition.
or
OK
,quit
9
view menus.