ページを印刷するFollowing are some helpful tips to make the assembly process smooth and efficient.
PRE-ASSEMBLIES:
(i.e. Post and Beam Assemblies, Roof Rafter Assembly, etc)
• Work on a raised, solid and flat surface such as, a table or saw horse.
• Keep all connections flush where shown in the instructions.
• When assembling the beams keep parts flat, straight and snug when
connecting.
METAL PARTS:
• Roofing material may have sharp edges, wear safety gloves.
• Remove all plastic covering, on both sides of the metal panels, directly
before installing each piece.
• Place roofing material on a non-abrasive surface before and after assembly
as it can bend, dent and scratch easily.
• The roofing screws can easily crush the roof panels and roof edges when
using a power drill. We recommend hand tightening the roofing screws so
they sit snug and tight to the roofing material.
Note: It is critically important you start with square, solid and level footings, concrete
pad or deck to attach your Pergola Room.
We supply Post Mounts with this structure which gives you the flexibility to permanently install your structure
to a pre-existing or new wood or concrete surface.
•
The hardware to attach the Post Mount to the structure is included.
•
The hardware to mount the structure permanently will need to be purchased separately at your local
hardware store.
If you are mounting to concrete footers see below for the correct locations and placement. Please double
check for possibility of any underground utilities such as gas, telephone, cable or sprinkler lines.
Following are some examples of how to mount the structure to wood or concrete surfaces.
Refer to your local building and city codes, ordinances, neighbourhood covenants, or height restrictions
regarding this type of structure for guidance on acceptable installation requirements.
Assembly Tips
Permanent Installation Examples
4