モデム AOR ARD9000のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。AOR ARD9000 2 ページ。 Aor digital voice modem quick start guide
AOR ARD9000 にも：取扱説明書 (19 ページ)

Quick-Start-Guide for AOR ARD9000

carefully reading may make your start into Digital-Voice much easier

We strongly recommend to use the provided speaker-microphone during your first test-

contacts. None of the factory set potentiometer settings, located on the underside of the

device, should be changed. Any adaptation of the work settings assumes experiences in

Digital-Voice as well as a co-hearing receiver or experienced test partner.

Attention especially the digital output setting would have to be carried out very precise.

!! DO NOT TRY TO "IMPROVE" THINGS WHICH ARE NOT NEEDED !!

CONNECTION:

In general it is recommended to connect the ARD9000 to a separate power supply, other than

•

the one used for the radio. However, attempts have shown that it does not necessarily lead to

complications if the DC power is taken from the same power supply. We managed to use the

ARD9000 and radio connected to the same supply without recognizeable problems - however,

it may vary from setup to setup and you have to check locally – if not working, better step

back to separate power-supplies for radio and ARD9000. Switched-power-supplies seem to

be mostly causing trouble and are not recommended to be used

Wiring the ARD9000 <> radio cable should be taken from the AOR manual. In case your

•

radio does not offer a PTT-L pin, you have to shortcut this one with GND. Shielded cable as

well as a good frame ground between both units are necessary

Usage of an external speaker, connected to the speaker-out connector, makes listening more

•

pleasantly

TRX SETTINGS:

TX output should not exceed 50 % of the maximum setting to avoid damage of your final

•

transistors. The Multi-Carrier-Digital-Signal (36 carriers) puts your final transistors under

stress in maximum power output

AGC setting should be FAST. Minimal required SSB bandwidth is 2.4 kHz - not to be limited

•

by internal filter settings or build-in DSP units

ALC readout should not exceed 60 % of max. level. Adjusting the max. ALC level should be

•

done by MIC-gain (TX side)

Your ARD9000 has been properly adjusted at the factory