- ページ 3
ネットワーク・ルーター AudioCodes Mediant 800のPDF クイック・セットアップ・マニュアルをオンラインで閲覧またはダウンロードできます。AudioCodes Mediant 800 10 ページ。 Gateway and e-sbc
ページを印刷するFXS port status LED:
FXO port status LED:
BRI port status LED
PRI (E1/T1) port status LED:
3
GE
Up to four Gigabit Ethernet (10/100/1000Base-T) ports (RJ-45) for connecting IP
phones, computers, or switches. The ports support 1+1 Ethernet port redundancy
(active-standby), half- and full-duplex modes, auto-negotiation, and straight-
through or crossover cable detection.
4
FE
Eight Fast Ethernet (10/100Base-TX) ports (RJ-45). For a description, see the GE
ports (above).
5
//
Reset pinhole button for resetting the device or restoring it to factory defaults
(press and hold down the button for at least 12 seconds, but no more than 25
seconds).
6
CONSOLE
RS-232 serial interface port (RJ-45).
7
USB/WWAN
USB ports, which can be used for various functionalities such as saving debug
captures to a USB storage device.
Green On
Phone is in off-hook position.
Green Flashing
Phone is ringing.
Red On
Off
Phone is in on-hook position or no power.
Green On
FXO line with PBX is in off-hook position.
Green Flashing
Ringing is detected from PBX.
Red On
Off
FXO line is in on-hook position or no power.
Green On
Physical Layer 1 is synchronized (normal operation).
Red On
Physical Layer 1 is not synchronized.
Off
BRI trunk is not active.
Green On
Trunk is synchronized (normal operation).
Red On
Loss due to any of the following signals:
Off
Failure or disruption in the power supply or power is
currently not being supplied to the device through the
power supply entry.
Green On
Ethernet link established.
Green Flashing
Data is being received or transmitted.
Off
No Ethernet link.
3 |
P a g e
Malfunction in line or out of service due to Serial
Peripheral Interface (SPI) failure.
Port is disabled.
Malfunction in line or out of service due to SPI
failure.
Port is disabled.
LOS (Loss of Signal)
LOF (Loss of Frame)
AIS (Alarm Indication Signal - Blue Alarm)
RAI (Remote Alarm Indication - Yellow Alarm)