- ページ 8

スピーカー Audiopipe DJAP-612PBのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Audiopipe DJAP-612PB 16 ページ。 Djap series hybrid portable pa system

42. BATTERY

These LEDs are used to indicate the power

of the battery.

43. EXT. DC 12V

When the AC and battery are out of power,

you can use the EXT. DC 12V supply to the

unit.

44. POWER AMP. Switch

Turn the Power AMP switch on "OFF"

position, the EXT. DC output will be cut

off, and the battery will store the power;

this switch on "ON" position, the EXT. DC

supply will work on normal condition.

45. SPEAKON Connector

This connector is used to connect with the

passive speakers. It is configured with a

speakon connector. You can determine the

signal that is out put to this jack.

NOTE: In order to avoid damaging your

built-in amplifier, please pay more attention

to the impedance of speaker. Lower load impedances are not permitted.

46. CLIP LED

When the output signal distortion exceeds 0.5%, then the red LED (Clip) indicator will blink. It will warn you that the levels of

the input signal are too high and may cause distortion. Please attenuate the level of the input signal.

47. TO MIXER

Put the Mixer on the bracket to adjust the volume, you can insert the connector into the TO MIX jack, and the unit can work on

normal condition.

48. PHONE Jack & SPEAKON Connector

These jacks are used to connect UPA-615 passive speakers. They are configured with a speakon connector and 1/4" phone jack.

You can determine the signal that is outputted to these jacks.

NOTE: In order to avoid damaging your built-in amplifier, please pay more attention to the impedance of speaker. Lower load

impedances are not permitted.

3.5 WIRELESS MICROPHONE SYSYTEM

Diversity Receiver

49. Antenna

The antenna receives signal from transmitter. Make sure the antenna is fully extended vertically for receiving best effect. Fold

both antennas inward for the convenience of transporting.

DJAP-612PB

DJAP-61PB DJAP-615P

DJAP-615P