- ページ 9

アンプ AUDIOPROF REVAMP2150のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AUDIOPROF REVAMP2150 16 ページ。

REVAMP2150

5. Bridge/2 channel mode selector:

enable bridge mode operation. Minimum load impedance in

bridge mode is 8 ohms. The yellow led underneath the switch

lights up when bridge mode has been activated. Always

disconnect the speaker(s) before (de-)activating bridge mode!

In bridge mode, the input signal from channel 1 is used.

6. Channel 2 speaker output on 2 pole euroblock connector.

7. Channel 1 speaker output on 2 pole euroblock connector.

8. Channel 2 unbalanced input and link cinch connector:

the line level input signal for channel 2 here. Line level is 0 dBV.

Input and link connector are internally connected 1 on 1.

9. Channel 1 unbalanced input and link cinch connector:

the line level input signal for channel 1 here. Line level is 0 dBV.

Input and link connector are internally connected 1 on 1. This

connector is also used in bridge mode.

10. Channel 2 balanced input on 3 pole euroblock connector.

11. Channel 1 balanced input on 3 pole euroblock connector:

connector is used in bridge mode.

12. Mains inlet:

connect the mains power cord here.

Instruction manual

push the selector switch to

connect

This