- ページ 10

セキュリティセンサー Abus Nexello PLMK10100のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Abus Nexello PLMK10100 19 ページ。 Bypass opening detector

Abus Nexello PLMK10100 取扱説明書

2.2. Planning, assembly and installation

The device uses low-power radio signals to communicate with the Z-Wave gateway. For best results,
please note the following:
The device has a radio range of up to 40 m.
The battery life of the device is reduced if the wireless connection to the Z-Wave gateway is not
direct but via a repeater.
Assembly instructions:
The detector is only suitable for indoor installation. The
device is suitable for mounting on wood and plastic
surfaces, from mounting on
Metal surfaces are urgently advised against for
technical reasons. Fasten the sensor holder to the
window or door. Place the base on the holder.
Fasten the holder of the magnet to the frame with the
enclosed adhesive pad or screws. Place the base on
the holder and, if necessary, change the height
adjustment of the magnet by pulling out the grid.
If necessary, use the supplied spacers to compensate
for differences in height between the sensor and the
magnet.
Ensure that the sensor and magnet are aligned
vertically according to the markings and that the tops
are as flush as possible.
Make sure that the horizontal distance between
sensor and magnet is as small as possible, the trigger
threshold is approx. 2cm.
10
English