- ページ 4

リモートスターター Audiovox 1285620のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Audiovox 1285620 6 ページ。 2 button remote keyless entry system with two auxiliary outputs

ページを印刷する

Note: In the event that you lose your keychain transmitter or the transmitter fails to

operate the keyless entry system, the valet switch can be used to override the optional

Starter Interrupt, and therefore allow the engine to be started. To override system:

1. Open the door with the vehicle's door key.

2. Turn the ignition switch to the on position.

3. Flip the valet/override switch to the on position. LED will turn on solid.

The system will disarm, allowing the engine to be started, and the vehicle to be operated

normally. Always remember to move the valet switch to the off position to allow the

passive arming and optional starter interrupt features to be operable the next time you

park the vehicle.

ELIMINATING THE LOCK/UNLOCK CHIRPS

You can selectively eliminate the normal lock and unlock chirps by holding the transmitter

button slightly longer when locking and unlocking. This will prevent the horn/siren chirps

for one lock or unlock cycle. If you find this inconvenient and wish to eliminate these

chirps permanently,

1. Start with the valet switch in the off position.

2. Turn the ignition switch "on" then "off".

3. Within 10 seconds of turning off the ignition, flip the valet switch on, "off", "on", "off",

"on", "off".

4. If the chirps were on before you started, the siren will emit 2 short chirps indicating

that the chirps are now off. If the chirps were off before you started, the siren will

emit one short chirp indicating that the chirps are now on.

REMOTE PANIC OPERATION

The left lock/unlock button of your keychain transmitter also serves as a panic button

and will cause the vehicle horn (or optional siren) to sound on demand. To use the panic

feature, you must be within the system's maximum operating range. In an emergency

situation, to use the panic feature, press and hold the left lock/unlock button of your

keychain transmitter for 3 seconds. This will cause the lights to flash, the vehicle horn (or

optional siren) to sound, and if the optional interior illumination circuit was installed, the

interior lights to flash. The panic mode will continue for 30 seconds and then reset.

To disengage the panic feature before the 30 seconds are up, press and hold the left

button of your keychain transmitter for 3 seconds or press the right button momentarily.

The doors can be unlocked or locked while in "panic" feature by momentarily pressing

the left button.

ADDITIONAL REMOTE FUNCTION CHANNEL 2

The system has an additional output, (Channel 2) , that can be connected to a number of

different optional accessories. Some of the more common uses for this channel are:

Remote Trunk Release

Remote Window Close

To operate the accessory associated with Channel 2, press and hold the right button of

your keychain transmitter for four seconds.

Page 4