- ページ 7

PCIカード Datapath VisionSDI2のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Datapath VisionSDI2 15 ページ。 Dual 3g-sdi capture card
Datapath VisionSDI2 にも：マニュアル (2 ページ)

ページを印刷する

Unpacking

Your packing box should contain the following items:

•

The VisionSDI2

•

Installation CD ROM

If there are any discrepancies, you should contact Datapath immediately.

Note:

All plug-in cards are static sensitive and are packed in anti-static material. Please keep the card in its

packaging until you are ready to install.

It is recommended that you do not discard the packing box until you are completely satisfied with the

VisionSDI2 capture card and it is fully installed and working correctly. We also recommend that you

make a note of the serial number of the card in a prominent place before the card is plugged into the

computer. This should hasten any query should you need to contact our Technical Support

Department. The serial number is displayed on the card itself and the box label.

Installing the Capture Card

You are likely to need a flat blade and a Phillips head screwdriver for the installation of the capture card; it

would be useful to have these to hand before you begin.

Installing the card is a simple process, follow the steps below to be up and running in a few minutes:

•

Power down the PC (including peripherals), switch off at the mains and disconnect all the cables

connected to the computer, noting the positions for accurate reconnection. Remove the PC cover

•

Locate a vacant PCIe (x4 or above) slot for the VisionSDI2 on the motherboard and remove the backing

plate (retain all screws)

identify a PCIe (PCI-express) slot. If the card is forced into a 32 or 64 bit PCI or PCI-X slot it will be

irreparably damaged when the system is powered up and the warranty will be void.

•

Remove the card from its packaging and secure it firmly into the empty PCIe slot. Extreme care

should be taken when securing the card into the slot as some motherboards may have

components that impede the siting of the card

•

Screw the card bracket to the back panel of the PC and replace the cover

•

Re-connect all cables to the PC

•

Connect the cable(s) distributing the signals to the connectors on the VisionSDI2 card located on the

back panel.

•

Power up the PC and commence the software installation.

If in doubt consult your motherboard documentation to correctly