- ページ 8

体重計 ADE M500020-CのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ADE M500020-C 16 ページ。 Electronic wheelchair and multipurpose scales

ページを印刷する

Do not use the set-up button as otherwise the calibration will be lost. This procedure is only al-

lowed to be done by authorized service personnel appointed by ADE (GmbH & Co.). Any unau-

thorized manipulations made to the configuration mode will affect the warranty agreement.

Safety instructions

The ADE-display unit (MAK) corresponds to the latest state of the art technology and complies with standard

regulations and directives. Kindly follow the safety instructions in this operating manual, the country-specific

installation standards as well as the applicable safety conditions and accident prevention regulations in all

aspects. Electronic medical devices are restricted to special safety regulations in respect of their electromag-

netic compatibility. For positioning and operation follow the instructions of this Operating Manual.

–

Modell M500020-D: The pre-installed seat is only allowed to be used by persons up to 100kgs.

–

Portable and mobile HF-communication systems may influence electronic medical devices.

–

The mains voltage and power type stated on the type plate should match the mains voltage and power

type at the place of use.

–

Make sure that the mains cable does not pose any potential trip hazard.

–

Do not operate the unit in hazardous or unstable conditions.

–

Do not submerge the unit in water or other liquids.

–

Set up the unit as far away as possible from equipment that generates electromagnetic or other interfer-

ence.

–

Only use original rechargeable batteries and power adapters from ADE. The Warranrty does not cover

any damage caused by using other types of batteries or charger units.

A safe operation is no longer guaranteed:

If the power unit exhibits visible damage.

If the power unit is no longer working.

After longer periods of storage in damp rooms.

In these cases inform your service partner.

The following functions are available in setting mode:

–

Configuration of the serial interface

–

Set up of date, time and consecutive printout numbers

–

Set up of print format

–

Set up of switching points

–

Test functions

The setting mode is not made for metrological parameters. Access the function menu by pressing the CLEAR

(13) key until TIME appears on the display. Use the key pad (13) to navigate within the menus, to select nu-

merical values and to increase or lower the values. Press the ENTER key to save the values entered and to

return to the super ordinate menu level.

Safety

Settings

M500020-210322-Rev009-UM-e