自動車アクセサリー AUSSIE TONNEAU ATR01146のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。AUSSIE TONNEAU ATR01146 4 ページ。 Continuous rope tonneau cover

1 x Tonneau Cover

Elastic Rope

1 x Tonneau Support Bar

3 x Aluminium Ropetrack (484mm Long)

1 x Fitting Instruction

Drill, 4mm Drill Bit, Tape Measure, Rivet Gun, Marking Pencil / Pen, Clear Silicone / Silicone Gun

1. INSTALATION PROCEDURE

NOTE

Read entire instructions prior to start.

1. Using two pieces of dowel join the 3 aluminum rope tracks together. Place the other 2 pieces of

dowel in the ends of the now joined rope track.

2. Rest the aluminum rope track on the side rails as Shown in Figure 1, and push forward to the

vertical face of the tub.

3. Using a 4 mm drill bit, drill 6 holes 50mm from the end of each of the aluminum rope tracks into

the front of tub.

4. Once all the holes have been drilled, remove the dowelling pieces. Squeeze silicon along the

back of the rope tracks and pop rivet into place.

5. To fit bar brackets measure 760mm back from the inside front edge at the top of the tub and

place them as shown in Figure 2. (5mm from top edge of tub). Drill and rivet using two large

rivets for each Bar Bracket. Install support bar.

6. To attach buttons measure and drill a hole, using the 4.5mm drill bit, 100mm down and 25mm

forward of the front inside edge of the tub.

7. Attach the triangle hook with rivets at the centre of the tailgate, above the handle.

8. Thread rope through each of the eyelets and tie off behind the front eyelet on each side

(Figure 4)

Tonneau Cover Fitting Instructions

Hilux Dual Cab, AUG 2005 – SEP 2015

Continuous Rope Tonneau Cover

Part number: ATR01146

BASIC TOOL REQUIRED

CONTENTS

2 x Bar Brackets

16 x Rivets

4 x Buttons

1 x Tri-hook

4 x Dowels