- ページ 5

浄水器 Austin Springs AS-WELLのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Austin Springs AS-WELL 7 ページ。 Whole house water filter and uv well kit

ページを印刷する

Use and Care

Component one: Pre-filter

• Sediment levels vary from one location to another. During the first year of use, a

visual inspection monthly is recommended. The sediment pre-filter is white when

you initially install it. Once you can no longer see white, it is time to replace the

filter with a new one (AS-WHPRE-4-R). Allowing sediment to continue to collect can

cause clogging and prevent the flow of water into your home.

Component two: Whole House filter

• This filter unit has a capacity of 300,000 gallons. You replace the unit in its entirety

every 300,000 gallons. Check with your plumber at the time of installation about

adding a meter to your system. Typically the average family of four will consume

that amount in 3-5 years. Unions are located on each side of the tank for ease

of replacement. It is not necessary to contract a plumber. The replacement part

number is AS-WH-R.

Optional Well Kit Components (Not NSF Certified)

Component three: Post-Filter

• The post-filter, utilized to remove particulates up to 60 times smaller than the eye

can see, should be replaced every nine months. This is an important step in the

sterilization of bacteria in the UV disinfection process. The water needs to be as

pristine as possible to prevent harmful bugs "hiding" behind any particulates. An

added benefit is that cysts (such as giardia or cryptosporidium) will also be captured.

Component four: UV filter

• Annual replacement of the bulb is a must. Contact Austin Springs

directly for the replacement bulb: part number AS-UV-R.

The steps to replace the bulb are included with the

replacement bulb.

Operating specifications

1. Read all precautions, installation, and operating instructions carefully and

completely before installing the unit.

2. Do not install this filter where the line pressure may exceed 100 psi.

Operating pressure range: 20psi – 100psi.

3. The rated service flow is seven gallons per minute; rated capacity is

300,000 gallons.

4. Sediment pre-filter cartridges should be changed as needed. (When you

can no longer detect the original white color of the filter, it is time for

replacement. Sediment levels vary greatly, so regular visual inspections

are recommended during the first year.)

5. Install on cold water lines only. Operating temperature range: 40° – 90°F.

Protect unit from freezing.

6. Do not install the unit on its side or in direct sunlight. Outdoor installation

requires the use of sunproof sumps. Please contact our sales and service

department 866-238-5855 to discuss your specific needs.

7. Installation of the filter must comply with existing state and local plumbing

codes. Austin Springs is not liable for consequential or incidental damages

due to improper installation.

8. Cleaning: use only warm, soapy water to clean the outside of the housing.

Rinse well with fresh, clean water. Never use chemical cleaning products on

the filter's exterior surface because they may damage the filter housing.

Do not use with water that is microbiologically

unsafe or of unknown water quality without

adequate disinfection before or after the system.

Systems certified for cyst reduction may be used on

disinfected waters that may contain filterable cysts.