- ページ 10

食器洗い機 BENDIX BDW 60のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。BENDIX BDW 60 20 ページ。 Dishwasher
BENDIX BDW 60 にも：取扱説明書 (20 ページ), 取扱説明書 (20 ページ)

ページを印刷する

Operating sequence

1. Check the filters

Ensure they are clean and properly positioned (see

"Maintenance and cleaning").

2. Press the MAINS ON push button

The MAINS ON indicator light will come on.

3. Check that there is rinse aid

and salt

The salt indicator light will illuminate if refilling is

necessary.

4. Load the dishes

Remove any scraps of food.

Pull the lower basket out and arrange the saucepans,

plates and cutlery in it.

Pull the upper basket out and arrange the plates,

saucers, glasses and cups etc. in it.

Slide the baskets back into the machine.

5. Ensure that the spray arms can

rotate freely

6. Measure out detergent

Add the required amount of detergent into the dispenser

according to the recommended quantity given in the

Washing programmes chart.

Close the detergent dispenser lid.

7. Close the dishwasher door

8. Setting and starting the programme

Press the push button corresponding to the required

programme: the indicator light corresponding to the

programme illuminates and the phase indicator lights for

that programme start flashing.

The start of the programme will occur after about 6

seconds from the last pressure of a programme push

button, in this time it is possible to change programme

simply pressing the push button of another programme.

Once the programme has started the phase indicator

lights will turn off except for the phase under way.

It is possible to interrupt the programme by:

opening the door

pressing the MAINS ON push button (in this case all

the indicator lights turn off)

Close the door again or press the MAINS ON push

button, the programme will start from the point in which it

was interrupted.

9. To cancel a programme in progress

A programme in progress can be cancelled at any time.

Press for about 3 seconds the push button of the running

programme until all indicator lights are off.

Only the MAINS ON indicator light will remain on once

the programme has been cancelled.

It is now possible to select a new washing programme.

10. At the end of the washing

programme

The dishwasher will automatically stop and the phase

indicator light end of programme will come on.

The indicator light of the programme just ended will

remain on.

The dishwasher has finished the programme only when

the end of programme (END) indicator light is illuminated.

If you do not wait for the end of the programme it will not

be possible to start a new programme if first you do not

cancel the previous.

(For instructions on how to cancel a programme see

point 9)

Switch off the dishwasher by pressing the MAINS ON

push button and open the door.

Wait a few minutes before removing the dishes; in this

way they will be cooler and drying will be improved.

Empty the lower basket first and then the upper one; this

will avoid water dripping from the upper basket onto the

dishes in the lower one.

Important!

In general it is not advisable to open the door while the

machine is working; if the door is opened however, a

safety device ensures that the machine stops.

Care must be taken if the door is opened during the hot

phase or immediately after a programme has finished, as

steam may escape.

When the washing programme has finished, it is

recommended that the dishwasher is unplugged and the

water tap turned off.