- ページ 16

食器洗い機 BENDIX BDW 60のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。BENDIX BDW 60 20 ページ。 Dishwasher
BENDIX BDW 60 にも：取扱説明書 (20 ページ), 取扱説明書 (20 ページ)

ページを印刷する

Installation instructions

Any electrical work required to install this appliance

should be carried out by a qualified electrician or

competent person.

Any plumbing work required to install this appliance

should be carried out by a qualified plumber or competent

person.

Remove all packaging before positioning the machine.

If possible, position the machine next to a water tap and a

drain.

Water supply connections

This dishwasher must be plumbed into a cold water supply.

The water pressure must be within the limits given in the

technical specifications.

Your local Water Authority will advise you on the average

mains pressure in your area.

The dishwasher features fill and drain hoses which can be

turned either to the left or the right to suit the installation.

The locknut must be correctly fitted to avoid water leaks.

Do not use, for the connection, old hoses which have

been used in another appliance.

Avoid bends or kinks in the hose which could prevent or slow

down the water supply.

If the machine is connected

to new pipes or pipes which

have not been used for a

long time, you should run the

water for a few minutes

before connecting the inlet

hose. This will prevent

deposits of sand or rust

clogging the inlet hose filter.

Water outlet hose connection

The end of the drain hose can be connected in the following

ways:

1. To the sink outlet spigot, securing it if necessary with a clip.

2. Hooked over the edge of the sink using the special curved

plastic guide provided.

3. To a stand pipe provided with vent-hole, minimum internal

diameter 4 cm.

CS09

The waste connection must be at a height of between 30 cm

(minimum) and 100 cm (maximum) from the bottom of the

dishwasher.

The drain hose can face either to the right or left of the

dishwasher

Ensure the hose is not bent or squashed as this could prevent

or slow down the discharge of water.

CA17

The sink plug must not be in place when the machine is

draining as this could cause the water to siphon back into the

machine.

If you use a drain hose extension it must be no longer than 2

metres and its internal diameter must be no smaller than the

diameter of the hose provided.

CS10

Likewise the internal diameter of the couplings used for

connections to the waste outlet must be no smaller than the

diameter of the hose provided.

Attention!

Our appliances are supplied with a security device to

protect against the return of dirty water back into the

machine.

If the spigot of your sink has a "no return valve"

incorporated this can prevent the correct draining of your

dishwasher.

We advise you therefore to remove it.

+ 2 m max