- ページ 4

ツール Gage Bilt 5U-615A-61のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Gage Bilt 5U-615A-61 4 ページ。

ページを印刷する

INSTALLATION INSTRUCTIONS

FOR ATTACHING TO GB715 TOOL

1. Make sure the head piston of the tools is in its full forward position

2. Connect power tool to air supply before attaching pulling head

3. Thread the pulling head onto the head piston and tighten jam nut (28)

INSTALLATION INSTRUCTIONS

FOR ATTACHING TO GB784 TOOL

For 5/32"-1/4" - Do NOT use GB784 to install 1/8" CherryLOCK rivets.

1. Connect power tool to air supply and make sure head piston of

the tools is in its full forward position

2. Tighten Jam nut (70411)

3. Install adapter (784715) to the tool.

Adapter

(784715)

Cherrylock® is a registered trademark of Cherry Aerospace Fasteners. Lubriplate® is a registered trademark of Friske Brothers Refining Co.

GAGE B I LT

● 615A-61 Pulling Heads

Seller warrants that all goods covered by this catalog will conform to

applicable specifications and will replace or repair, EXW. our plant, any

goods providing defective from faulty workmanship, or material, for 1 year

from date of shipment

Said warranty to remain in effect if, and only if, such goods are used

in accordance with all instructions as to maintenance, operation and use, set

forth in manuals and instruction sheets furnished by seller.

Sellers obligation under this warranty shall be limited to the repair or

rework of the goods supplied or replacement thereof, at Seller's option, and

in no case is to exceed the invoice value of said goods. Under no

circumstances will the seller be liable for incidental or consequential

damages or for damages incurred by the buyer or subsequent user in

repairing or replacing defective goods or if the goods covered by this

warranty are reworked or subjected to any type of additional processing.

This warranty is void if Seller is not notified in writing of any

rejections or defects 1 year after the receipt of the material by the customer.

THIS WARRANTY IS MADE IN LIEU OF ALL OTHER WARRANTIES

EXPRESSED OR IMPLIED, INCLUDING MERCHANTABILITY.

INSTALLATION INSTRUCTIONS

FOR ATTACHING TO GB784 TOOL cont.

Note: The shift point setting on the tool must be adjusted to

compensate for the longer stroke when using adapters.

4. Remove limit pins.

5. Turn adjusting knob counter-clockwise until it stops.

The GB784 will now install Cherrylock rivets upt to 1/2" grip

length. Before using a straight 681 series pulling head again,

the tool must be re-adjusted using stroke setting gage (784159).

See GB784 tool manual for instructions.

WARRANTY

Adapter

(784715)

Adjuster Knob

Limit Pin

Rev. 3/18