- ページ 16

セキュリティシステム ADEMCO TI110B1のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ADEMCO TI110B1 18 ページ。 Gsm/pstn dual network burglar alarm system

negative electrodes. If you don't want to wired sensor, please don't take off the short

circuit wire.

(4) Extern Siren Wiring: there is an output terminal for external siren in the alarm panel. And

when wiring , please pay attention on the electrodes of siren and alarm panel to ensure

that you have a right wiring (Note: Red Line is positive and Black Line is negative)

(5) Telephone Wiring: please insert the crystal plug of the telecommunication line into the

"Telephone Line" interface of the alarm panel, and the telephone is inserted into the

"Telephone" interface.

(6)

"Alarm Tone" and "Alarm/Mute" optional: you are allowed to choose the alarm tone with

according to your real need. And it also supports "Alarm/Mute" optional. When the volume

switch is at the "Alarm" place, the alarm host will sound alarm in the field. And when it is

turn to the "Mute" place, the alarm host will not sound alarm but still sends the alarm

information out to the alarm receiving number

(7) Install Protective Cover: In order to protect from the wrong operation from others, please

install the protective cover and fasten screws on the side of the host where there are " Edit ","

Power ", "Alarm Volume " "Alarm/Mute " switches after installation and debugging.

Ⅵ.Technical Parameter:

GSM module: TC35i or TC35 Industrial-grade module

GSM frequency: EGSM 900 and GSM 1800

GSM module Voltage: 3.3—4.8V/ Working Current: 300mA (average)

GSM Consumption power: 2W (EGSM900); 1W (GSM1800)

SMS support format: AT, Text and PDU

Baud rate: 300bit/s –115kbit/s optional

Data transceiver mode: Asynchronous Serial interface (ITU-T RS232)

The 20-second prerecording alarm language segment through the digital recording chip

DTMF telephone dialing standard frequency: low frequency group: 697、770、852、941Hz;

high frequency group: 1209、1336、1477、1633H;Distortion: more than 1.5%

Level: the low frequency group:- 9dbm、3dm ; the high frequency group:-701 dbm、3dm

The distortion that cause by harmonic wave and intermodulation: at least 20db than the level

of fundamental wave, the signal limiting length:＞40ms digit, discharge parameter quantity:

＜15db

Exit delay: 000-255 seconds adjustable

Entry delay: 000-255 seconds adjustable

Power output: DC 12V, 100mA

Frequency: 315MHz/433MHz optional

External siren: 12V wired siren (110dB)

Working environment : temperature: 10℃~+45 ; relative humidity:≤95%

Power supply: AC220V±15%；DC 9.6V/600mA or 12V/600mA (optional)

℃