ページを印刷する
i ¸ ,,,,_
m
m
TENSIONING
THE RUNNING BELT
The running belt has been properly adjusted at the
factory before it was shipped. At times the belt can
move off-center during shipment.
CAUTION: Running belt should NOTbe moving during
tensioning. Over-tightening the running belt can
cause excessivewear on the treadmifl as weft as its
components.Neverover-tighten the belt.
If you can feel a slipping sensation when running on the
treadmill, the running belt must be tightened. In most
cases, the belt has stretched from use, causing the
belt to slip. This is a normal and common adjustment.
To eliminate this slipping, TURN TIlE TREADMILLOFF
and tension BOTH THE REAR ROLLER BOLTSusing the
supplied allen wrench, turning them 1/4 TURN to the
right as shown. Turn the treadmill on and check for
slipping. Repeat if necessary, but NEVER TURN the
roller bolts more than 1/4 turn at a time. Belt is properly
tensioned when the slipping sensation is gone.
Beltistoo far to the right side
Beltis too far to the leftside
CENTERING THE RUNNING BELT
Therunning belt has been properly adjusted at the
factory before it was shipped. At times the belt can
move off-center during shipment. Before operating the
treadmill, make sure the belt is centered and remains
centered to maintain smooth operation.
CAUTION:Do not run belt faster than 1/2 rnph while
centering. Keep fingers, hair and clothing away from
belt at all times.
If the running tier is too far to the right side:
With the treadmill running at J/2 mph, turn the right
adjustment bolt clockwise 1/4 TURN at a time (using
the supplied aden wrench). Check the belt alignment.
Allow belt to run a furl cycle to gauge if more adjustment
is needed. Repeat if necessary, until the belt remains
centered during use.
If the running tier is too far to the left side:
With the treadmill running at J/2 mph, turn the right
adjustment bolt counter-clockwise J/4 TURNat a time
(using the supplied Allen wrench). Check the belt
alignment. Allow belt to run a furl cycle to gauge if more
adjustment is needed. Repeat if necessary, until the
belt remains centered during use.
(_
HEART
RATE
(9..........®
F1
Manual
F2
SpeedI_,te_ vals
R3
I_oli_eIntevals
P70_tom
1
P8
C_stom 2
qJ
ID
(_DISTANCE
(_)SPEED
(_CALORIES
7
8
9
4
5
6
1
2
3
A) PROGRAM PROFILE DISPLAY.. Displays workoutprofiles.
B) ADDITIONAL DISPLAY WINDOWS: Time,Incline,Heart Rate, Distance,Speed,Calories.
C) CLOCK/DATE WINDOW: Displayseither Clockor Date.
D) PROGRAMMING BUTTON: Usedto select Program,Leveland Time,and other options. Pressto changedisplay feedback
during workout.
E) START.. Simplypress to begin exercisingor starts your workout.
F)
STOP: P ressto pause/enflyour workout.Hold for 3 secondsto reset the treadmill.
G) INCLINE ARROW KEYS: P ressto adjust incline (÷/- 0.57/oo increments).
N) SPEED ARROW KEYS: P ressto adjust speed (÷/- O.JMPHincrements).
I)
QUICK ADJUST KEYPAD: Usedto reach desiredspeedor incline morequickly.
))
AUDIOIN (NOT SHOWN).. Plugyour CD/ MP3playerinto the consoleusing the includedaudio adaptor cable.
K) AUDIOOUT/NEADPNONE JACK(NOT SHOWN).. Plugyour headphonesinto this jack to listen toyour music through the
headphones.
i
iii_ i
_ii_ii_i
_!!I i I _I_!I_I
2.0AT
Rev.l.9.indd
16-17
3/3/08
11:12:32AM