- ページ 5

セキュリティセンサー ADEMCO Honeywell 5806 W3のPDF トラブルシューティングマニュアルをオンラインで閲覧またはダウンロードできます。ADEMCO Honeywell 5806 W3 9 ページ。 Smoke & heat detector

Smoke & Heat Detector Troubleshooting

Testing the Smoke Detector

To test that your smoke detector is functioning properly:

1. Place your system in Test mode. Please refer to the

2. Locate the Test Switch on the detector housing. This may be a recessed switch or a visible button.

3. Depress the Test Button, if present. For a recessed test switch, use a small screwdriver or Allen key

(no more than 0.18" diameter) to push and hold the recessed test switch for at least 5 seconds. The

smoke detector LED should blink once per second and the smoke detector sounder (not the system

siren) sound within 3 seconds, indicating that the detector is functioning properly. Release the Test

Button or remove the tool from the recessed switch to silence the smoke detector sounder.

4. Remove your system from Test mode. Please refer to the

Heat Detector Trouble Conditions

Heat Detectors do not have LEDs or sounders to indicate trouble conditions. Any trouble

conditions detected will show on your alarm keypad. Note: the actual message will vary

depending on your keypad model. Please refer to the

for details about your keypad model.

https://alpha.adt.com/help/89[11/12/2018 9:58:31 PM]

System Test

System Panel Troubleshooting

opening above batteries.

page.

page