- ページ 8

コントロールパネル ADEMCO VISTA-20SEのPDF プログラミング・フォームをオンラインで閲覧またはダウンロードできます。ADEMCO VISTA-20SE 8 ページ。 2-partitioned security system
ADEMCO VISTA-20SE にも：ユーザーマニュアル (4 ページ), ユーザーマニュアル (9 ページ), プログラミング・フォーム (8 ページ)

ページを印刷する

ZONE LISTS FOR OUTPUT DEVICES –

below and follow the procedure in the installation manual as you enter the data during the displays and prompts that

appear in sequence.

Note:

Record desired zone numbers below. More or fewer boxes than shown may be needed, since any list may

include any or all of system's zone numbers.

Zone List 1: Started or stopped by zone numbers (enter 00 to end entries).

Zone List 2: Started or stopped by zone numbers (enter 00 to end entries).

Zone List 3: Started or stopped by zone numbers AND/OR assignment of Chime zones (enter 00 to end entries)

Zone List 4: Assignment of common lobby zones (enter 00 to end entries).

SPECIAL MESSAGES

OC = OPEN CIRCUIT (no communication between Console and Control).

EE or ENTRY ERROR = ERROR (invalid field number entered; re-enter valid field number).

After powering up, AC, dI (disabled) or Busy Standby and NOT READY will be displayed after approximately 4 seconds. This

will revert to READY in appx. 1 minute, which allows PIRS, etc. to stabilize. To bypass this delay, press: [#] + [0].

If E4 or E8 appears, more zones than the expansion units can handle have been programmed. Correct the programming and

then completely de-power and re-power the control to clear this indication and remove the disable indication.

TO ENTER PROGRAMMING MODE:

1. POWER UP, then depress [

2. Initially, key: Installer Code (4 + 1 + 1 + 2) plus 8 + 0 + 0.

3. If different Installer Code is programmed, key: New Installer Code + 8 + 0 + 0.

(if

98 was used to exit previously, method 1 above must be used to enter the program mode again)

TO EXIT PROGRAMMING MODE:

Exits programming mode and prevents re-entry by: Installer Code + 8+ 0 + 0. If

mode, system must be powered down, and method 1 above used to enter the programming mode.

Exits programming mode and allows re-entry by: Installer Code + 8 + 0 + 0 or: Power-up, then press "

within 50 seconds of power up.

] and [#] both at once, within 50 seconds of powering up.

A L A RM DE V I CE MA NUFA CTURI NG CO .

A DIVISION OF PITTWAY CORPORATION

165 Eileen Way, Syosset, New York 11791

This is an interactive mode. Fill in the required data on the worksheet

98 is used to exit programming

...etc.

" and "#"