ページを印刷する
EN
08 S ide s uction
Page 10
NOTE :
A pair of side suction flap is
provided to increase the
vacuum path width up to 45cm.
Use this side suction flaps only if
your pool has good flat bottom
without pool liner pleats
otherwise will slow down the
pool cleaner robot significantly
or even stop the cleaner robot
from moving.
8.1: Flip the pool cleaner robot
upside down
8.2: Place the flaps onto the pool
cleaner robot as shown.
8.3: Then tight it up by the screw
provided
09 Cleaning the impeller
NOTE :
Some debris can clog or be
wrapped around the impeller of
the pump. By force, these debris
can hinder the proper
functioning of the robot or even
damage the engine.
Regular visual inspection is part
of the normal maintenance of the
robot.
9.1: Remove the flap assembly
to clean the dirt or hair on
impeller
9.2: Use a flat screw driver to ply
the flap assembly out as shown
9.3: Snap the flap assembly back
after cleaning