ページを印刷する8. ATTACHING THE FAN
BLADES
Caution: Remove 5 rubber packing mounts and
discard before installation.
Step 1 Attach the blade to the blade bracket using
the screws and fiber washers as shown in Figure
18. Start screw into bracket. Repeat for the two
remaining screws.
Step 2 Tighten each screw. Make sure the blade is
straight.
Step 3 Fasten blade assembly to motor using the
screws supplied. (Fig. 18)
9. INSTALLING THE
LIGHT KIT
(OPTIONAL)
NOTE: Before starting installation, disconnect the
power by turning off the circuit breaker or removing
the fuse at fuse box. Turning power off using the
fan switch is not sufficient to prevent electric shock.
Step 1. Remove the switch housing cover from the
switch housing.
Step 2. Raise and hold the light kit close to the switch
housing and proceed to do the wire connections,
connect the blue wire from the switch housing to the
black wire from the light kit. follow the same procedure
with the black connectors. Use the wire connecting
nuts supplied with your fan. (Fig. 19)
Step 3. Attach the light kit to the switch housing by
using the three (3) screws provided. (Fig. 19)
Screws
Blades bracket
Figure 18
Wire nuts
Switch
housing
Light kit
Figure 19
9
10. INSTALLING THE
LIGHT BULBS AND
GLASS SHADES
(OPTIONAL)
NOTE: Before starting installation, disconnect the
power by turning off the circuit breaker or removing
the fuse at fuse box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
Screws
Fiber
1. Insert the glass shades into the light kit with the
washers
thumb screws. (Fig. 20)
Blade
2. Install 40W candelabra bulbs (included).
(Fig. 20)
3. Restore power and your light kit is ready for
operation.
1. Install 60W candelabra bulbs (included).
(Fig. 21)
2. Secure bowl glass to light fitter using supplied
nut. Next install trim cover followed by the finial.
3. Restore power and your light kit is ready for
operation.
Screws
Light kit
Glass shades
Bulbs
Figure 20
Light kit
Glass Bowl
Figure 21
10
Screws
Bulbs