ページを印刷するFor better performance and comfort, it is recommended
•
the collection bag is emptied when it becomes
approximately half full. This reduces the weight and also
allows the vac operation to perform at its highest level.
Maintenance and storage information
Prior to cleaning or any maintenance, always ensure the
power plug has been removed from the electrical power
supply.
When you have finished using the blower vac, always
check to make sure the product is clean and free of dirt and
debris. This is important around the selector lever flap which
is just inside the round outlet. To check this area, remove
the collection bag and ensure this area inside the outlet
tube is free of debris and dirt.
Operate the selector lever backwards and forwards to
ensure correct operation.
Do not hose or submerge any part of the blower vac.
Do not use solvents to clean the blower vac.
Store the blower vac in a dry place, and out of reach of
children.
Power cord maintenance
If the supply cord needs replacing, the task must be carried
out by the manufacturer, the manufacturer's agent, or an
authorised service centre in order to avoid a safety hazard
Important notes when using the
blower/vacuum selector lever
Do not force the lever.
The lever should move with very
little resistance. If the lever is difficult to move, disconnect
the power supply, remove the collection bag and ensure
debris, dirt or mud has not jammed the lever.
When selecting either of the operations, ensure the selector
lever is fully in one position or the other, not half way.
Extension cord support
During use of the blower vac, the extension cord will
continually be pulled as you move from one area to another.
An extension cord support has been provided on the
housing of the blower vac to assist in preventing the
electrical connection between the extension cord and
blower vac plug being forced apart.
Note.
The support is for the extension cord, and not the
cable from the blower vac.
1. To fit the extension cord to
the support, make a tight
loop in the extension cord,
approximately 300mm from
the socket on the extension
cord.
2. Fit the loop into the square
recess in the back portion
of the blower vac on the
underside of the housing.
3. Push the loop all the way through the housing by
approximately 25mm.
4. Push each side of the loop downwards so each side of
the loop fits over the hook inside the recess.
5. After, and only after the cable is correctly seated, plug the
blower vac plug into the socket of the extension cable.
12