- ページ 10

試験装置 AFL FlexScan FS200 OTDRのPDF クイック・リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。AFL FlexScan FS200 OTDR 13 ページ。 With smartauto, flexpress and linkmap

1. Touch to enable/disable light source. RED dot indicates that source is ON.

2. Touch to select test mode: Wave ID, CW, Tone (270 Hz, 330 Hz, 1 kHz, 2 kHz).

– Select Wave ID mode for fastest loss measurements.

While in this mode, the FlexScan source transmits wavelength information, enabling a Wave ID power meter

to synchronize and measure power at received wavelength(s).

– Use CW mode to generate continuous wave light at a single wavelength.

– Generate Tone for fiber identification (270 Hz, 330 Hz, 1 kHz, 2 kHz).

3. Touch to select test wavelength: 1310, 1550 or 1650 nm (depending on model).

4. If used with non Wave ID source, touch to

select wavelength. If used with Wave ID source,

power meter automatically synchronizes to and

indicates received wavelength(s).

5. Hold to store new reference(s) at received

wavelength(s). Touch Ref/Set to view stored

reference(s).

6. Touch to toggle between power (in dBm or

Watts) and loss (dB) mode.

Note: Power meter detects and indicates fiber

identifying tones when used with a light source

capable of generating a modulated Tone signal.

Light Source and Power Meter Operation