- ページ 3

トイレ MAINLINE ML100WのPDF 取り付け説明書お手入れとメンテナンスをオンラインで閲覧またはダウンロードできます。MAINLINE ML100W 11 ページ。 Round front toilet

ページを印刷する

Round Front Toilet

Devant de cuvette rond

Installation Instructions, Care and Maintenance

Adjustments

a. Adjust water level. Water level should be adjusted to level

indicated on tank by adjusting the float cup. See Step 11 for water

level adjustment method.

b. If bowl fails to siphon, an adjustment may be required with the lift

chain. Simply remove the bead chain from the retainer clip, take up

slack on the chain and re-insert on lift rod. Make sure the chain is not

too taut.

Troubleshooting

DIAGRAM 1: IMPORTANT:

Always clear sand and rust from system.

Make sure water supply is off. Remove

valve TOP by lifting arm and rotating top

and arm 1/8 turn counter- clockwise,

pressing down slightly on cap.

DIAGRAM 3: Replace TOP by engaging

lugs and rotating 1/8 turn clockwise.

MAKE CERTAIN TIP IS TURNED TO THE

LOCKED POSITION VALVE MAY NOT

TURN ON IF TOP IS NOT FULLY TURNED

TO THE LOCKED POSITION.

IF FILL VALVE WON'T TURN ON OR SHUT OFF or REFILL OF TANK WATER IS SLOW

(After valve has been in use for some time).

Fluidmaster Replacement Seal may be needed.

VITREOUS CHINA

Adjust Water Level

a. Turn on water supply. Submerge the

FLOAT CUP under the water for 30

seconds. Adjust the water to desired

level by turning WATER LEVEL

ADJUSTMENT ROD and moving FLOAT

CUP up or down.

b. Once water level is correct with marking in tank, flush toilet 3 times

to prime toilet and "No Overflow" system. After prime has been

established toilet traps are self-priming from this point on. No further

priming is required. Use toilet for normal use.

Care and Cleaning

When cleaning your toilet, wash it with mild soapy water, rinse

thoroughly with clear water and dry with a soft cloth. Avoid detergents,

disinfectants, or cleaning products in aerosol cans. NEVER use abrasive

scouring powders or abrasive pads on your toilet seat. Some bathroom

chemicals and cosmetics may damage the seat's finish.

WARNING:

Do not use in-tank cleaners. Products containing chlorine (calcium

hypochlorite) can seriously damage fittings in the tank. This damage can

cause leakage and property damage. Mainline shall not be

responsible or liable for any tank fitting damage caused by the use of

cleaners containing chlorine (calcium hypochlorite).

DIAGRAM 2: While holding a container over

the uncapped VALVE to prevent splashing,

turn water supply on and off a few times.

Leave water supply off.

IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY:

Repeat Step 13.

IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE:

It is a signal you are wasting water because:

a. The end of the refill tube is not inserted into overflow pipe, below

water level in tank. Attach refill tube to overflow pipe.

b. The flush valve is leaking because it's worn, dirty or misaligne

flapper (replace with a new flapper).