- ページ 3

トイレ MAINLINE MLS10421のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。MAINLINE MLS10421 14 ページ。 Dual flush round and elogated toilets

WARNINGS AND CAUTIONS

• Handle with care. Vitreous chinaware is glass-like with sharp edges if broken. Do not drop,

handle roughly or overtighten bolts.

• Risk of hazardous gases. If new toilet is not installed immediately, temporarily plug floor flange

hole with a towel (or cover) to block sewer gases from escaping.

• Observe local plumbing and building codes.

PREPARATION

• Before beginning installation of product, make sure all parts are present. Compare parts with

package contents list and diagram above. If any part is missing or damaged, do not attempt to

assemble, install or operate the product. Contact customer service for replacement parts.

• Estimated Assembly Time: 60 minutes

• Tools Required for Assembly and Installation (not included): Toilet Water Supply Line,

Adjustable Wrench, Putty Knife, Flathead Screwdriver, Hacksaw, Carpenters Level.

ASSEMBLY INSTRUCTIONS

1. Remove Old Toilet

• Turn off water supply and flush tank completely. Towel or sponge remaining water from tank

and bowl.

• Disconnect and remove old water supply line.

• Remove tank from bowl by removing old tank-to-bowl hardware.

• Remove bowl from floor by removing bolt caps and floor bolt nuts.

• Remove floor bolts from toilet flange and clean old wax, putty and sealant from base area.

(Temporarily plug floor flange with a towel or cover to block sewer gases from escaping.)

• NOTE: MOUNTING SURFACE MUST BE CLEAN AND LEVEL BEFORE NEW TOILET IS

INSTALLED.

2. Install Floor Bolts (AA*), (Figure 1)

• Insert new floor bolts (AA*) into the toilet flange

(not included) with bolt heads down and threaded

ends facing up (use plastic retaining washers

(BB*) to hold bolts in full-length, upright position).

• Floor bolts (AA*) should be parallel to wall and 6

inches apart.

*AA, and BB not included.

Figure 1