- ページ 5

自転車アクセサリー Maintronic Sx2 Tuning-DongleのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Maintronic Sx2 Tuning-Dongle 5 ページ。 For ebike; with bosch active / bosch performace line cablekit sx2kb-perf

Sx2KB-Plus Power-Switch Bosch Cablekit
Manual with equipped light on the Bosch engine
If your eBike with Bosch engine has already light ins-
talled and the light function on the control computer
is enabled, one of the two existing light cables need to
be connected to our Sx2KB-Plus power switch cablekit.
To use the option, the Sx2 Tuning-Dongle with the light
switch on and off.
Use cable for front or
rear light strip approx.
10-15cm
For this purpose, the insulation need to be removed
about 10-15 cm behind the plug from one of the two
light cables.
Please take care not to damage the single wired.
The insulation of the two wires has to be removed ap-
prox. 1 cm.
Kink the cables and
twist the wires.
Connect the twisted wires to the terminals on the termi-
nal block (terminal designation 1).
Please observe polarity:
red = positive pole; black = minus;
Carl-Zeiss-Str. 10-14
97424 Schweinfurt / Germany
Either the front or rear light can be connected. It is only
important to connect the light cable to the input with
the (1) (to the right of the speed sensor connection (S).
To connect cables to the terminal block, use a screwdri-
ver to push the white lever, as shown in the picture
below, to the left in the direction of the opening and
insert a stripped cable into the opening. Then push the
lever to the right again. Check cable for tightness.
Terminals
for
light
cable + = red / - = black
Both wires (+ red and - black) must be connected. If the
cable for the light is connected to the terminal block
(terminal designation 1), the speed sensor with the in-
sulation displacement terminal can be connected accor-
ding to the operating instructions.
Finally, put the plug back into the engine compartment.
to light
speed sensor
plug
Tel. +49(0)9721-7766 0
Fax. +49(0)9721-7766 18
Lighting plug to Bosch
engine
www.maintronic.de