ページを印刷する6
OPERATING INSTRUCTIONS
Indicator Light Instruction
Brushroll
Jam Indicator
Normal Operation:
When the vacuum cleaner is turned on:
· The LED screen shows the remaining usage in minutes.
· The corresponding "Suction Power Mode" icon
flashing).
· The "Battery Power Monitoring Loop"
· The "Battery Power Monitoring Loop"
Indicator Troubleshooting:
1.
"Brushroll Jam Indicator"
brush if:
· The "Brushroll Jam Indicator" flashes until the screen goes off.
· The LED light on the floor brush is off.
· The floor brush stops rotating.
2.
"Suction Blockage Indicator"
cup, and filters if:
· The "Suction Blockage Indicator" flashes until the screen goes off.
· The LED light on the floor brush is off.
· The floor brush stops rotating.
9
Low Battery Alarm
When charging, the blue light is steady (not flashing).
And it will turn red and flashes quickly when the
power is lower than 10%.
Suction Blockage
Indicator
Battery Power
Monitoring Loop
Suction Power Mode
is steady (not
indicator is steady (not flashing).
decreases as battery power decreases.
— Check for and clear out blockage in the floor
— Clear out blockage in the suction port, dust
3.
"Low Battery Alarm"
— recharge the battery if:
· The "Low Battery Alarm" — turns red and flashes.
· The minimum charge indicator on the battery pack is flashing.
4.
"Battery Power Monitoring Loop"
indicator flashes along with one of the followings:
· The number display shows a flashing
Allow it to cool for 30 minutes before using again.
· The number display shows a flashing
warmer temperature.
· The number display shows a flashing
voltage. Unplug the adapter and replace with the correct one.
Crevice Tool Instruction
With brush: Press the button to
move the brush back to the fixed
position to clean the dust.
— Follow battery care steps below if this
— The battery temperature is too high.
— The battery is too cold. Use in a
— The adapter is over or under
Without brush: Push the brush
forward to the fixed position to clean
the particles from the crevices.
10