- ページ 3

スイッチ Maiwe MIEN2208-FのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Maiwe MIEN2208-F 5 ページ。 Industrial ethernet switch

Hardware installation

Installation Precautions

To prevent equipment damage or personal injury caused by improper use, observe

the following precautions:



During the installation process, you need to wear anti-static gloves or anti-static

gloves, and power-off the switch.



Please make sure that the input voltage is within the input voltage range marked

on the switch.



The transmission distance has a certain relationship with the connected wire. It

is recommended to use a standard Cat5e/6 network cable.



The equipment must be grounded for lightning protection, otherwise the

protection level of the equipment will be greatly reduced; please use a wire of No.

20 or more to connect the grounding terminal to the ground.



The power line, ground line and signal line are laid out separately and the

distance is not less than 5cm.

Device installation



Tilt the switch upwards so that the upper end of the buckle is fastened to the

upper end of the DIN rail.



The lower end of the back buckle is buckled into the DIN rail.

Device connection



Network cables connection

Connect the optical fiber and network cable to the port in the correct

Catagory5 direct connection



Optical fiber connection

Connect the optical fiber to the corresponding optical fiber interface. The optical

fiber interface is used in pairs (TX and RX as a pair), TX is optical receiver, RX is

optical sender.

Catagory5 crossover connection