- ページ 8
室内暖炉 decorflame M100-25FAOのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。decorflame M100-25FAO 12 ページ。 Electric fireplace heater
ページを印刷する1. Drill a 5/16" (8 mm) hole in the wall. Insert
the PLASTIC WALL ANCHOR into the hole
and gently tap until the flange on the anchor
is against the wall surface.
2. Position the back edge of the mantel close
to the wall.
3. Attach the SAFETY CABLE to the mantel
using the SCREW FOR MANTLE. See fig. I
4. Use the SCREW FOR WALL to attach the
other end of SAFETY CABLE to the wall.
5. Make sure all screws are tight.
After reading complete instructions, confirm
all controls on fireplace are in the OFF posi-
tion. Plug the fireplace into a 15AMP/120Volt
outlet. If the cord does not reach, you may
use an extension cord rated for a minimum
of 1875 WATTS. Once the fireplace insert
has been properly connected to a grounded
electrical outlet, it is ready to operate.
O P E R A T I O N
Fig. I
8
OPERATION BY
THE CONTROL PANEL
The controls are located behind the grill
below the front glass and can be accessed
by pulling the grill from the top, forward and
down.
O/I: Press this button for main power and
flame effect. The indicator light will turn on.
See below for other control switches.
1250W: For heat function - Press this switch
while the O/I switch is in the ON position. The
indicator light will turn ON.
Temperature Control: To adjust the tempera-
ture to your individual requirements, turn the
temperature control dial to the right (clock-
wise) to increase the desired temperature
and to the left for lower temperature. This
temperature control dial can only be used
while the O/I switch and 1250W switch are in
the ON position.