室内暖炉 decorflame M902L-42FDCのPDF マニュアルをオンラインで閲覧またはダウンロードできます。decorflame M902L-42FDC 8 ページ。 Electric fireplace heater

ページを印刷する

design forward living

IMPORTANT:

NOTE: DO NOT RETURN UNIT TO THE STORE

BEFORE CONTACTING OUR CUSTOMER

SERVICE DEPARTMENT. DO NOT DISPOSE

OF YOUR CARTONS UNTIL YOU ARE

COMPLETELY SATISFIED WITH YOUR NEW

FIREPLACE HEATER.

PLEASE NOTE: WHEN YOU OPEN THE CARTON CAREFULLY CHECK THE UNIT

AND MAKE SURE THERE IS NO DAMAGE. IF YOU HAVE ANY PROBLEMS WITH

THE UNIT, WITH HOW THE VARIOUS FUNCTIONS WORK, DAMAGED OR MISSING

PARTS PLEASE CALL 1-844-455-4621 IMMEDIATELY FOR SERVICE.

NOTE: Light bulbs may become loose during shipping. If the ﬂame effect is dim or does

not work, please check that light bulb or bulbs are ﬁnger tight in socket. See instructions

for replacing bulb or bulbs.

INSTRUCTION MANUAL

ATTENTION:

1. Find a location for the electric ﬁreplace heater that is protected from direct sunlight.

2. Do not plug the unit into the power outlet before reading all instructions.

IMPORTANT SAFETY INSTRUCTIONS

WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS SHOULD ALWAYS

BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND INJURY

TO PERSONS, INCLUDING THE FOLLOWING:

1) Read all instructions before using this electric ﬁreplace heater.

2) This electric ﬁreplace heater is hot when in use. To avoid burns, do not let

bare skin touch hot surfaces. If provided, use handles when moving this

heater. Keep combustible materials, such as furniture, pillows, bedding,

papers, clothes, and curtains at least 3 feet (0.9 m) away from the front of

the unit and keep them away from the sides and rear.

3) Extreme caution is necessary when any heater is used by or near children or

individuals with disabilities and whenever the electric ﬁreplace heater is left

operating and unattended.

4) Always unplug electric ﬁreplace heater when not in use.

5) Do not operate any heater with a damaged cord or plug or after the heater

malfunctions, has been dropped or damaged in any manner.

6) Do not use outdoors.

7) This electric ﬁreplace heater is not intended for use in bathrooms, laundry

areas and similar indoor locations. Never locate electric ﬁreplace heater

where it may fall into a bathtub or other water container.

ELECTRIC F IREPLACE

HEATER

Model: M902L-42FDC (NDF-62N)

8) Do not run cord under carpeting. Do not cover cord with throw rugs, runners,

or similar coverings. Do not route cord under furniture or appliances. Arrange

cord away from trafﬁc area and where it will not be tripped over.

9) To disconnect electric ﬁreplace heater, turn controls to off, then remove plug

from outlet.

10) Connect to properly grounded outlets only.

11) Do not insert or allow foreign objects to enter any ventilation or exhaust

opening as this may cause an electric shock or ﬁre, or damage the heater.

12) To prevent a possible ﬁre, do not block air intakes or exhaust in any manner.

Do not use on soft surfaces, like a bed, where openings may become blocked.

13) A heater has hot and arcing or sparking parts inside. Do not use it in areas

where gasoline, paint, or ﬂammable liquids are used or stored.

14) Use this electric ﬁreplace heater only as described in this manual. Any other

use not recommended by the manufacturer may cause ﬁre, electric shock, or

injury to persons.

15) Avoid the use of an extension cord because the extension cord may overheat

and cause a risk of ﬁre. If you must use an extension cord, the cord must be

14 AWG and have a minimum rating of 1875 watts.

16) Caution: Do not plug this product into a receptacle controlled by a wall switch

or dimmer.

17) When storing or transporting the unit and cord, keep in a dry place, free from

excessive vibration and store so as to avoid damage.

SAVE THESE INSTRUCTIONS FOR FUTURE USE.

CAUTION:

IF YOU USE THIS HEATER IN CONJUNCTION WITH A THERMAL CONTROL, A

PROGRAM CONTROLLER, A TIMER OR ANY OTHER DEVICE THAT SWITCHES THE

HEATER ON AUTOMATICALLY, REMEMBER TO OBSERVE ALL SAFETY WARNINGS

AT ALL TIMES. THE FIREPLACE HEATER HAS SAFETY OVERHEAT PROTECTION. IF

THE OVERHEAT PROTECTION TRIPS, SWITCH OFF ALL SWITCH BUTTONS AND WAIT

APPROXIMATELY 5 -10 MINUTES. IT SHOULD RESET AUTOMATICALLY ONCE THE

UNIT COOLS DOWN.

WARNIN WARNING DO NOT LOAD MORE THAN 22.7KG(50LBS) ON THE TOP SHELF

WARNING:

PROCEDURES AND TECHNIQUES IF NOT CAREFULLY FOLLOWED WILL RESULT

IN DAMAGE TO THE EQUIPMENT AND WILL EXPOSE THE USER TO THE RISK OF

SERIOUS INJURY, ILLNESS OR DEATH.

THIS ELECTRIC FIREPLACE HEATER IS FOR USE ON 120 VOLTS. THE CORD HAS

A PLUG AS SHOWN AT A IN ILLUSTRATION BELOW. AN ADAPTER AS SHOWN AT

C IS AVAILABLE FOR CONNECTING THREE-BLADE GROUNDING-TYPE PLUGS TO

TWO-SLOT RECEPTACLES. THE GREEN GROUNDING PLUG EXTENDING FROM

THE ADAPTER MUST BE CONNECTED TO A PERMANENT GROUND SUCH AS A

PROPERLY GROUNDED OUTLET BOX. THE ADAPTER SHOULD NOT BE USED IF A

THREE-SLOT GROUNDED RECEPTACLE IS AVAILABLE.

A 15 AMP CIRCUIT IS REQUIRED TO OPERATE THIS HEATER. IF THE BREAKER

TRIPS WHEN THE HEATER IS USED THEN YOU MAY NEED TO MOVE THE HEATER

TO ANOTHER LOCATION OR UNPLUG OTHER APPLIANCES THAT ARE ON THE

SAME CIRCUIT. IF YOU REQUIRE AN EXTENSION CORD USE ONE THAT IS RATED

AT 1875 WATTS.