- ページ 9

ゲートウェイ ADF Web HD67154-B2のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ADF Web HD67154-B2 15 ページ。 Gateway / bridge, ethernet from/to devicenet master

Industrial Electronic Devices

UPDATE DEVICE:

Section "Update Firmware" (Fig. 6):

In order to load the parameters or update the firmware in the device, follow these instructions:

Turn off the Device;

Connect the Null Modem Cable form your PC to the Gateway;

Insert the Boot Jumper (For more info see Fig. 1 or Fig. 2);

Select the COM port and press the "Connect" button;

Turn on the device;

Check the BOOT Led. It must blink quickly (For more info see Fig. 1 or Fig. 2);

Press the "Next" button;

Select which operations you want to do.

Press the "Execute update firmware" button to start the upload;

When all the operations are "OK" turn off the device;

Disconnect the Boot jumper;

Disconnect the RS232 Cable;

Turn on the device.

At this point the configuration/firmware on the device is correctly update.

Note:

When you install a new version of the software it is better if the first time

you do the update of the Firmware in the HD67154-xx device.

Warning:

If the Fig. 7 appears when you try to do the Update before require

assistance try these points:

Check if the serial COM port selected is the correct one;

Check if the serial is connected between the PC and the device;

Try to repeat the operations for the updating;

If you are using a dongle try with a native COM port or change the dongle;

Try with another PC.

ADFweb.com Srl – IT31010 – Mareno – Treviso

User Manual Ethernet from/to DeviceNet Master

Document code: MN67154_ENG

Figure 6: "Update Device" windows

Figure 7: "Protection" window

INFO:

Revision 1.000

www.adfweb.com

Phone +39.0438.30.91.31

Page 9 of 14