ページを印刷する
Industrial Electronic Devices
PING DEVICE:
If is necessary to do a Ping on the net, before pressing the
UPDATE DEVICE VIA SERIAL:
Section
"Update Via
Serial" (Fig. 5):
In order to load the parameters or update the firmware in the gateway, follow these instructions:
Turn off the device;
Connect the Null Modem cable from your PC to the gateway;
Insert the Boot Jumper (see the Fig. 1,2 for more info);
Turn on the device;
Check the "BOOT Led". It must to blink quickly (Seethe Fig. 1 for more info);
Select COM port and press the "Connect" button;
Press the "Next" button;
Select operations you want to do. Can select only Firmware or only Project or both;
Press the
"Execute update
When all the operations are "OK" turn off the device;
Disconnect the Boot jumper;
Turn on the device.
At this point the configuration/firmware on the device is correctly updated.
ADFweb.com S.r.l.
"Ping
Device" button insert a value in the right field and then press the button.
firmware" to start the upload;
Figure 5: "Update Via Serial" windows
User Manual Modbus Master / Ethernet
Document code: MN67506_ENG
Revision 1.012
Page 10 of 18