- ページ 2

送信機 Airgineers Force V2のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Airgineers Force V2 3 ページ。 48-channel video transmitter

Switching Bands, Channels, and Power Output

All of the functions on the Force V2 VTX are controlled via a single push button. A series of

coloured LEDs on the board are used to indicate band, channel and power output. Please refer

to fig. 1 and fig. 2 for explanation.

Switching channel

A short press of the button changes the frequency. The channel number is displayed using the

three green LEDs (see fig. 2)

Switching band

Press and hold the button for around 2 seconds until the blue LEDs start flashing, then release.

A short press whilst in this mode will change band. The band is displayed using the three blue

LEDs (see fig. 2) which will continue to flash throughout the process. Once the correct band has

been selected, wait 5 seconds and the blue LEDs will stay on solidly to indicate the process is

complete.

Switching Power Output

Press and hold the button until the red power indicator LED is on solidly then release. A short

press whilst in this mode will move to the next power output. The current power output is

indicated by a combination of the green and blue LEDs (see fig. 3). Once the correct power

mode has been selected, wait 5 seconds. The red LED will now flash to indicate the power

mode (see fig. 1)

Please note: Only the 25mW mode is permissible in the UK and in the Airgineers competition.

100mw, 200mW, 400mW and 600mW modes should not be used in the competition.

fig. 1 – Power output indication

Power output mode during normal use is displayed via a single red LED using a flashing

sequence as below:

Flash sequence

1 flash, off for 3 seconds

2 flashes, off for 3 seconds

3 flashes, off for 3 seconds

4 flashes, off for 3 seconds

5 flashes, off for 3 seconds

Permanently on

Mode

25mw

100mw

200mw

400mw

600mw

Fault