- ページ 12
ツール Airglas GLH3000 Nose SkiのPDF 耐空性継続のための指示をオンラインで閲覧またはダウンロードできます。Airglas GLH3000 Nose Ski 17 ページ。 Ski kit for piper pa-18, pa-12, cc-18, s-18-180, sky international, inc. aviat a-1, a-1a, a-1b, a-1c-180, a-1c-200
ページを印刷するoperating, and servicing the system. The fluid level should not be lower than 1/3 full in the
reservoir, and should only be serviced with the cylinder fully retracted to prevent overflow.
MAINTENANCE AND GROUND HANDLING RESTRICTIONS
1. DO NOT – Push or Pull on skis to move aircraft.
2. DO NOT – Subject to flame or high heat.
3. DO NOT – Attempt to jack aircraft using the skis for a Jack Point.
4. DO NOT – Subject to harsh solvents or caustic chemicals.
5. DO NOT – Use skis as a tie down for the aircraft.
6. DO NOT – Attempt to change a tire with the skis installed.
7. DO NOT – Rely on standard wheel chocks with skis installed.
1. CHECK – Bungees, cables, clevis pins, cotter pins, nuts, bolts and attach fittings for security.
2. CHECK – Cylinders for leaks at the seals and fittings.
3. CHECK – Hydraulic pump fluid level and inspect for leaks, and wiring connections.
4. CHECK – GLH3000 Ski Kit for cracks, excessive wear, fractures, abrasions, and delamination.
5. CHECK – Door Guides for wear and security. Lube with silicone spray or wax.
1. INSPECT – The GLH3000 Ski for:
2. INSPECT – The Forward Bungee, Safety Cable Assy. and Rear Check Cable
Page Revision A
(6.0 I nstructions for Continued Airw orthiness, -Continued)
MANUAL REVISION B
THIS MANUAL INCLUDES INFORMATION PROPRIETARY TO
(5.0 Servicing I nform ation-Continued)
6.0 Instructions for Continued Airworthiness
MAINTENANCE OPERATIONAL CHECKS
10-14 Check (10 hour or 14 day inspection)
INSPECTION CRITERIA
(100 hour or Annual inspection interval)
Cracks, wear, fractures and abrasions. Inspect the bottom for cracks, scratches,
delamination, and excess wear. If fibers are exposed or damaged, consult
Airglas. If ski shows signs of delamination, contact Airglas. Inspect the door
guides for wear and security. Lubricate guides with silicone spray or wax.
Assy. for integrity, wear, abrasion and fraying. Inspect all associated hardware
for security. Replace bungees when frayed or tension is less than 70 pounds in
most slack position.
Airglas, Inc.
ASSEMBLY WITHOUT THE PRIOR WRITTEN PERMISSION OF
Airglas, Inc.
100/Annual
AND SHALL NOT BE USED TO MANUFACTURE OR REPRODUCE ANY PART OR
Airglas, Inc.
Manual # GLH3000-105
27 July 2011
12 |
P a g e