- ページ 7

試験装置 ALIGNER CCD2.0WIFIのPDF インストールとマニュアルをオンラインで閲覧またはダウンロードできます。ALIGNER CCD2.0WIFI 16 ページ。

The Figure 8 page appears. Pressing the F5 key

At the end of the search the references of the detectors found are reported; press F4

Attention: if the WiFi search of the detectors does not generate results, try to enable/disable the broadcasting setting;

pressing the Alt+F2 keys shows the appearance as set out below:

 Broadcasting enabled /

Note: with the access point normally supplied, Zyxel NBG6604, the search is carried out with broadcasting disabled.

When the WIFI association is completed, the two icons in the

lower right corner turn BLUE.

Instead, if the association has not been carried out (or the front

detectors are off) these icons are GREY.

Note: the Bluetooth icons highlighted in RED indicate that the SW

driver that manages the system is not already running

Important: to test the actual connection with the detectors, use the

communication test (FW release) described in para. 6.1

At this point it is possible to carry out the calibration and test procedures (chap. 5 and chap. 6).

will start the WIFI search.

Figure 8

Figure 9



Broadcasting disabled (default selection)

R0368

Cod. R0368 ‐ rev.1.0

(03/2020)

to confirm.

Page 5/14