- ページ 22
オーブン AEG 7332543534333のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG 7332543534333 32 ページ。
ページを印刷する22
www.aeg.com
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
1
Install the shelf supports in the opposite
sequence.
10.4 Pyrolysis
CAUTION!
Remove all accessories and
removable shelf supports.
Do not start the Pyrolysis if
you did not fully close the
oven door. In some models,
the display shows "C3"
when this error occurs.
WARNING!
The appliance becomes very
hot. There is a risk of burns.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them
when the Pyrolysis function
operates. It can cause
damage to the appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Set the Pyrolysis function. Refer to
"Oven functions".
4. When
set the necessary procedure:
2
flashes, press
or
Option
P1
P2
Press
or turn the knob for the
temperature to start the procedure.
You can use the End function to delay
the start of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. When the oven is at its set
temperature, the door locks. The
display shows the symbol
bars of the heat indicator until the
door unlocks.
To stop Pyrolysis before it is
completed, turn the knob for the
oven functions to the off position.
6. When Pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
7. When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.
10.5 Cleaning reminder
To remind you that the Pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the appliance.
The cleaning reminder
goes out:
• after the end of the
Pyrolysis function.
• if you press
the same time while PYR
flashes in the display.
to
Description
If the oven is
not very dirty.
Time of the
procedure: 1
h.
If you cannot
easily remove
the dirt. Time
of the proce-
dure: 1 h 30
min.
and the
and
at