- ページ 8

KNOWING YOUR SEWING MACHINE — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Main power and sewing

light switch

This switch turns the main power and sewing light on or off.

1 Turn on (toward the 'I' mark)

2 Turn off (toward the 'O' mark)

CAUTION

●

Do not turn on the machine while pressing

down the foot controller. The machine

may start unexpectedly and cause

personal injury or damage to the machine.

When you press the foot controller down lightly, the

machine will run at a low speed. When you press harder,

the machine's speed will increase. When you take your

foot off the foot controller, the machine will stop.

1 Slower

2 Faster

You should make sure that nothing is placed on the foot

controller when the machine is not in use.

CAUTION

●

Do not allow pieces of cloth and dust to

build up on the foot controller. Doing so

could cause a fire or an electric shock.

Note

(For U.S.A. only)

● Foot Controller: Model KD-1902

This foot controller can be used on the

machine with product code 885-X13.

The product code is mentioned on the

machine rating plate.

7

1

2

1

2

The sewing needle must always be straight and sharp

for smooth sewing.

■ Checking the needle correctly

Put the flat side of the needle on a flat surface.

Check the needle from the top and the sides.

Dispose of any bent needles safely.

1 Parallel space

2 Level surface (bobbin cover, glass, etc.)

CAUTION

●

Always turn off the machine before you

change the needle. Otherwise, injuries

may occur if the foot controller is

accidentally pressed and the machine

starts sewing.

●

Only use sewing machine needles for

home use. Other needles may bend or

break and cause injury.

●

Never sew with a bent needle. A bent

needle will easily break and cause injury.

Turn off the machine.

1

Raise the needle by turning the

2

handwheel toward you

(counterclockwise) so that the mark on

the wheel points up.

Lower the presser foot lever.

3

1 Presser foot lever

1

2

1