- ページ 10

浄水器 AlkaViva The ionpia H2のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AlkaViva The ionpia H2 13 ページ。

Operation

Note: If your ionpia H is connected directly to your cold water

line, skip step 1 and start at step 2.

1. Turn your tap water onto cold, then turn the lever on your

diverter valve. This will divert the water from the tap to The ionpia

. At this point, check all connections for leaks,

tighten or re-seat if needed. If the diverter is leaking at the

faucet, use Teflon tape.

2. Place your glass under The ionpia H

flow control knob to the right to start water flow.

3. It is important to flush the filters before you start drinking the

water, after initial installation or filter replacement.

Do this by running water through the unit for several

minutes (or just until it is clear) and discard the water.

* Some discoloration can be expected but may not always be

present when flushing the filters.

Replacing your lters

Replacing your filters in a timely manner as recommended by the manufacturer is very important

for optimum hydrogen production as well as producing the healthiest, contaminant-free water.

• DO NOT disconnect any of the fittings or plumbing inside of The ionpia H

necessary and will void your valuable warranty.

• Be sure to change the filters one at a time as they need to be installed in the correct

position.

The filters ARE NOT INTERCHANGEABLE.

1. Turn off source water either at your tap or at the Angle Stop Adapter.

2. Place a container under the water dispenser and turn flow control knob to the right to start

the flow of water and remove any residual water inside your ionpia H .

3. Open Filter Cover.

water outlet and turn the

Page 10

HYDROGEN GENERATOR

. This is not