- ページ 10

舶用機器 Garmin Colorado 400cのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Garmin Colorado 400c 40 ページ。 Oregon series
Garmin Colorado 400c にも：オーナーズマニュアル (48 ページ), クイック・リファレンス・マニュアル (2 ページ), クイック・スタート・マニュアル (2 ページ), オーナーズマニュアル (48 ページ), 重要な安全情報 (48 ページ), オーナーズマニュアル (26 ページ), (デンマーク語）マニュアル (48 ページ)

400c

nstallIng the

IshFInder

Step 3: Install the Transducer

Proper transducer installation is key to getting the best performance

from your fishfinder. If the transducer lead is too short, extension

cables are available from your Garmin dealer. Coil and secure any

excess cable.

CAUtION: DO NOT cut the transducer lead or any part of

the transducer cable, because cutting the transducer cable voids

your warranty. The cable cannot be spliced and connected to any

existing (Garmin or non-Garmin) transducer cables.

The following pages contain tips and basic installation instructions

for some popular transducers. Detailed installation instructions are

provided in the transducer kits. Some transducers might have to be

installed by a professional marine installer.

Assembling the Transducer

To assemble the transducer:

assemble the transducer:

1. Insert the rubber washer and plastic spacer into the

transducer at the same time. DO NOT lubricate the rubber

washer.

2. Route the cable toward the back of the transducer. Slide the

transducer into the transducer mount.

3. Place a 5 mm flat washer on the 10-32 x 1.75" screw, and

insert the screw through the transducer mount, spacer, and

rubber washer.

4. Place the remaining 5 mm flat washer on the exposed end.

Install the 10-32 lock nut finger tight. You can tighten the

transducer further after installation on the boat.

Back of the transducer

Cable tie slot

Fishfinder 400C Owner's Manual