- ページ 10

食器洗い機 AEG F45078I-MのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG F45078I-M 19 ページ。 18” fully integrated dish washer
AEG F45078I-M にも：ユーザーマニュアル (35 ページ), 一般マニュアル (43 ページ)

ページを印刷する

1. Front Panel

Only run a soak program with half loads.

After using the above table to choose the most suitable washing cycle, program

the appliance.

2.2.1

Switching on

Press on/off (ref. 1 fi g. 2-02) to start the dishwasher; the indicator lights show the

"status" of the dishwasher.

2.2.2

Selecting and starting the program

•

Press the program

cator light corresponding to the required program turns on (ref. 4 fi g. 2-02);

•

if necessary, press the relative buttons to select the complementary functions

you wish to use (e.g. "Programming delay");

•

to start the dishwasher, press the

seconds until the indicator light of the selected program starts fl ashing (con-

fi rmation beep);

•

Program status is indicated by the indicator light fl ashing throughout the

cycle.

Before starting a washing program, make sure that:

•

The water supply tap is

•

There is regenerating salt

see the instructions in the general manual).

•

The correct amount of detergent

er (to add detergent, see the instructions in the general manual).

•

The spray arms are able to rotate

•

The racks have been

general manual).

•

The dishwasher door

Programming operations can only be performed with the door closed.

With the door open, the program indicator lights (ref. 4 fi g. 2-02) remain

off .

selection button (ref. 3 fi g. 2-02) several times until the indi-

If the door of the dishwasher has not been closed or has been incorrectly

closed, the washing cycle will not begin.

USER INSTRUCTIONS

open.

in the water softener tank (to add salt,

has been added to the dispens-

freely and without obstruction.

correctly loaded (see the instructions in the

is securely closed.

start/pause button (ref. 2 fi g. 2-02) for a few

Rev 0.0